piece to remove the bit of onionskin that was left, and
my wife cut and hand-sewed on every ribbon!
In the end, the medals were a huge hit with the
participants, and something that was only possible
with our CNC machine. ;
On the CNC, the first step was the 5mm hole for the
ribbon. Then came a V-bit for the logo and ring around the
outside. A 3/8-inch downcutting bit cut out each medal,
leaving just a small onionskin to prevent movement while
Show us your shop!
What ways are you using CNC technology that is
different from the norm? Is your shop a cut above the
rest? Take us on a virtual tour for your chance to be
featured on Woodworking Network and in FDMC!
To share photos of your setup and check out
what other people are doing in theirs, go to https://