6 (631)750-3000 www.monarchmetal.com
For a typical 8’ high x 4’ wide panel,
customers mount the continuous lengths
along the wall at 3 different heights parallel with
the floor. These are secured to studs at 16” on
center or to blocking at 8”on center. The shorter
panel clips are secured to the back of the panel
every 12-15” horizontally.
To match fastener locations on the panel
with those on the wall a single template
can be used or one can use a story pole.
Installation of the panel is accomplished
by simply dropping the panel onto the
continuous lengths mounted along the wall.
For a video of an installation, please visit
our web-site at MonarchMetal.com
Monarch recommends a #8 Pan Head
thread screw for attaching the shorter
panel clips to the back side of MDF or
particle board panels, and stocks these
in 1/2”, 5/8” and 3/4” lengths.
The important constraint to remember
for using the Monarch Z Clip system is
that the height of the head of the screw
must be less than .125” for our standard
Monarch Z Clips.